Some links in this guide are affiliate or referral links. No Bars Club may earn a commission from qualifying purchases at no additional cost to you. Read the full disclosure.
Parts list
| Part | Link |
|---|---|
| CT battery holder Battery mounting/holder | View part ↗ |
| Solar panel Primary solar source | View part ↗ |
| IPEX to N-type connector RF bulkhead/pigtail | View part ↗ |
| Antenna kit External antenna hardware | View part ↗ |
| RAK starter RAK radio starter hardware | View part ↗ |
| Project box Weather-resistant enclosure | View part ↗ |
| CCTV mount Pole/wall-style mounting arm | View part ↗ |
| Waterproof glands Cable entry sealing | View part ↗ |
| SMA male to N female cable, 2 ft Optional RF jumper | View part ↗ |
| Alternate solar panel Alternate panel option | View part ↗ |
| Silicone sealant Weatherproofing | View part ↗ |
| Self-fusing silicone tape Outdoor connector sealing | View part ↗ |
Build process
- Bench-test the radio
Flash and configure the RAK hardware before installing it in the enclosure. Confirm Bluetooth/USB access and radio operation.
- Lay out the enclosure
Dry-fit the board, battery holder, RF bulkhead and cable glands. Keep RF cable bends gentle and leave access to USB/reset controls where possible.
- Drill and mount
Install the N-type bulkhead, glands and CCTV mounting hardware. Deburr openings before installing seals.
- Connect RF and power
Attach the IPEX/U.FL pigtail carefully, connect the battery system and route the solar lead through a waterproof gland.
- Seal the enclosure
Apply silicone around penetrations as needed and use self-fusing silicone tape on outdoor RF joints.
- Deploy and test
Mount the node with the antenna vertical, confirm solar charging, then run range/message tests before leaving it unattended.
Build notes
- Do not transmit without a properly connected antenna.
- CCTV arms make it easier to aim the solar panel and position the enclosure away from obstructions.
- Inspect outdoor seals periodically, especially after freeze/thaw cycles.
This guide was adapted from No Bars Club's working build notes. Product availability, pricing and firmware can change, so verify compatibility before ordering or powering hardware.
Open Notion source ↗